DT ConfigureDataTakerTCPIPConnection.vi
LabVIEW DataTaker Driver >> DataTaker Low Level >> DT ConfigureDataTakerTCPIPConnection.vi
Generates dataTaker TCP/IP configuration using the specified TCP/IP settings.
Notes
- dataTaker hardware must be preconfigured to use the IP address specified by the IP address input, and the TCP/IP port specified by the remote port input.
Error Message Generated
- No specific errors are reported from this VI.
Controls and Indicators
|
DT type shows the type of dataTaker that is connected (DT800 or the DT500 family). |
|
IP address is the IP address of the dataTaker hardware. |
|
remote port (8) is the port to connect to on the dataTaker hardware. |
|
The error in cluster can accept error information wired from VIs previously called. Use this information to decide if any functionality should be bypassed in the event of errors from other VIs.
The pop-up option Explain Error (or Explain Warning) gives more information about the error displayed. |
|
The status boolean is either TRUE (X) for an error, or FALSE (checkmark) for no error or a warning. |
|
The code input identifies the error or warning. |
|
The source string describes the origin of the error or warning. |
|
connection data config out contains information about a dataTaker connection. |
|
connection type is the type of connection used to communicate to the dataTaker.
|
|
TCPIP IP address is the IP address of the dataTaker hardware.
|
|
TCPIP IP remote port is the port to connect to on the dataTaker hardware.
|
|
modem phone number is the phone number used to connect to, using a modem connection.
|
|
port config: serial port configuration options (data bits, stop bits, parity, and flow control are ignored when using DARTS protocol). |
|
parity is the parity used for the connection. The DT 500 uses none, while the DT800 uses none, odd, or even parity. |
|
stop bits specifies the number of stop bits used to indicate the end of a frame. |
|
data bits is the number of bits in the incoming data. |
|
baud rate is the rate of transmission |
|
flow control sets the type of control used by the transfer mechanism. |
|
DT serial contains the serial session configuration information. |
|
protocol: specifies whether to use standard serial communications, or the DARTS protocol (DT500 only). |
|
VISA resource name: the VISA resource to use for serial communications (ignore when using DARTS protocol). |
|
DARTS reference Reference to a DT DARTS object. |
|
serial buffer reference Reference to a DT SerialBuffer object. |
|
modem max dial in time is the maximum amount of time in ms, to try to dial in before timing out. |
|
DT type shows the type of dataTaker that is connected (DT800 or the DT500 family).
|
|
The error out cluster passes error or warning information out of a VI to be used by other VIs.
The pop-up option Explain Error (or Explain Warning) gives more information about the error displayed. |
|
The status boolean is either TRUE (X) for an error, or FALSE (checkmark) for no error or a warning.
|
|
The code input identifies the error or warning.
|
|
The source string describes the origin of the error or warning.
|
(C) 2003 dataTaker Pty Ltd & ICON Technologies Pty Ltd
www.dataTaker.com
www.icon-tech.com.au
|
|
