Connection of RS232 port to PC

The dataTaker DT80M is a 5 channel smart data logger with built in modem for remote internet connectivity

Connection of RS232 port to PC

Postby Brindha » Thu Jun 15, 2017 5:51 pm

Hi,

I am a student researcher. We have dt80m model. We need to connect a controller to the dt80m through a rs232 port and need to view the information in PC. Since dt80m doesnot have a rs232 port.

Can i convert the rs232 to rs485 and then connect it to PC for retrieving information? Is it even possible?

Thank you for your support
Brindha
Newbie
 
Posts: 1
Joined: Mon Feb 27, 2017 6:18 pm

Re: Connection of RS232 port to PC

Postby Roger » Fri Jun 16, 2017 12:29 pm

Good afternooon Brindha

The serial sensor port can be RS232 RS422 or RS485.
Set the profile for the serial sensor port the the mode you want then connect your device.

Cheers

Roger
"Don't Panic"
Douglas Adams HHGTTG
Roger
Guru
 
Posts: 262
Joined: Fri Feb 10, 2012 10:38 am

Re: Connection of RS232 port to PC

Postby Rudy Gunawan » Wed Jun 21, 2017 3:56 pm

Hi Brindha,

Thanks Roger.

There is a second serial port (called as serial sensor port or sersen port) located in front of the logger (green terminal with label Rx Tx RTS CTD and DGnd) for multi purpose.
You may set sersen port into RS232 and connect DT into PC, make sure to change the function to COMMAND for enable command control (from PC).

However downloading data does not need RS232 port, you may utilise Ethernet or USB connection to access dEX web interface.
After starting dEX, go to Monitor the Logger - select Retrieve Data and CSV format.

Best regards,
Rudy Gunawan
Rudy Gunawan
Guru
 
Posts: 409
Joined: Sun Apr 29, 2012 12:28 am


Return to DT80M

Who is online

Users browsing this forum: No registered users and 1 guest

cron