On page 32 of the CANgate users manual. There is a sentence (listed below) about the options for the response to a poll command.
"These commands will normally send a poll command (RP memslot) then parse the response
and either log it directly or assign it to a channel variable (CV)."
In the past I have frequently used the option of logging the response directly. This has worked well, and from the example shown not too hard to understand with my limited programming knowledge.
However I would like to assign the response to a CV, so I can use it as an alarm or trigger.
Is it possible to get more detail on how this command should be written so response is assigned to a CV rather than logged directly?